Contact Us
TEL: +86-510-88718069
Fax: +86-510-88718069
E-mail: harrylong@lbrollformer.com
Address: No.1 Wankun Road, Xinba Industrial Zone, Xishan District, Wuxi City, Jiangsu, China
Home > Knowledge > Content
Garage Door roll forming Machine Features and Safe Operating Procedures
May 26, 2018

In recent years, the performance of the Garage Door roll forming Machine has been continuously improved. Not only has the work efficiency increased significantly, but also the consumption has been reduced. The use of the door has been more energy-efficient and environmentally friendly, and the environmental pollution has been reduced, bringing more benefits to the market. In general, the garage door forming machine uses galvanized steel plates or different color steel plates or aluminum plates as raw materials to obtain garage door products.

 

By comparison, products made with the Garage Door roll forming Machine are not only brilliant in color, but also do not fade or rust, and are therefore widely used, and their strength is three times higher than that of an aluminum alloy door.

 

Garage Door roll forming Machine main features:

1. Garage Door roll forming Machine has the advantages of simple operation, small maintenance workload, easy commissioning and easy mold replacement;

2. The Garage Door roll forming Machine adopts high-level automatic control software to realize production information management;

3, the entire unit automation control system uses a highly integrated network, so that the performance of the automated system is more superior.

 

About the safe operation of the garage door molding machine:

First of all, as users, we need to strictly abide by safety procedures and prepare for production in advance;

 

Secondly, before opening the device, the upper and lower molds must be cleaned and wiped clean, and the size of the equipment and the feeding jig must be adjusted according to the size of the material to be processed.

 

The next step is to switch the garage door forming machine to the “ON” position, switch the device switch to the “forward” position, and fine-tune the speed control knob of the device.

 

After that, the material to be processed is placed in an appropriate position, and the staff appropriately adjusts the speed control knob to speed up the operation of the equipment until the material is processed. In this process, it should be noted that the edge material cut into the process is involved in the equipment;

 

Finally, the finished material must be inspected to confirm that it can meet the requirements of the cycle operation. After the work is completed, the garage door forming machine operation button should be turned to the “stop” position, the speed control button should be turned to zero, and the device switch should be set to the “OFF” position. In addition, the Garage Door roll forming Machine needs to be wiped clean, and related accessories should be properly kept.

http://www.longborollformer.com/

Previous: How is the shutter door forming machine using effect?

Next: Features of Color steel roll forming machine