Contact Us
TEL: +86-510-88718069
Fax: +86-510-88718069
E-mail: harrylong@lbrollformer.com
Address: No.1 Wankun Road, Xinba Industrial Zone, Xishan District, Wuxi City, Jiangsu, China
Home > Knowledge > Content
Installation requirements and processing technology of Hydraulic Cutter Perforated Shutter Door Roll Forming Machine
Aug 11, 2018

The Hydraulic Cutter Perforated Shutter Door Roll Forming Machine  can use a set of continuous frames to roll the stainless steel into a complex shape during the operation, and the metal sheet can effectively pass through a series of continuous rollers to achieve continuous deformation and obtain a predetermined schedule. The processing of the shape.

The method of hydraulic tool perforating the roller door roller forming machine is to use a set of continuous frames to roll the stainless steel into a complex shape. In the operation, the order of the rollers is such that the roller shape of each frame can be continuous during operation. The metal is deformed until the desired final shape is obtained. If the shape of the part is complex, up to thirty-six racks can be used, but the parts are simple in shape.

Hydraulic Cutter Perforated Shutter Door Roll Forming Machine will be economical due to the high processing cost and installation cost of the tool. Only when the output is more than 30,000 meters, the roll forming process is adopted. However, the trial production of stainless steel by a roll forming machine using a carbon steel profile is still unclear. In this case, care must be taken to prevent surface contamination or abrasion, and the equipment must be left with stainless steel for cold hardening and a high rebound margin.

The Hydraulic Cutter Perforated Shutter Door Roll Forming Machine  effectively comprises a frame, a top roller, a bottom roller and a guide rail, a bottom roller, a guide rail and a top roller movable on the frame are mounted on the frame, and the guide rail is mounted to be movable on the guide rail The positioning block, the positioning block and the front bezel of the set on the bottom roller are connected. One end of the top and bottom rolls is provided with a roller locking device. A top roller adjusting bolt and a pressurizing nut are provided on the top roller. In use, raise the top roller, adjust the front baffle to the required position through the positioning block, place the processed steel plate between the two rollers, adjust the pressure nut, press the steel plate to the desired shape, and then lock the roller. The locking device can be produced by starting the device.

http://www.longborollformer.com/


Previous: Advantages and technical requirements of highway guardrail rail forming machine

Next: Application field and operation requirements of Color Steel Roof Roll Forming Machine