Contact Us
TEL: +86-510-88718069
Fax: +86-510-88718069
E-mail: harrylong@lbrollformer.com
Address: No.1 Wankun Road, Xinba Industrial Zone, Xishan District, Wuxi City, Jiangsu, China
Home > Knowledge > Content
Start button and sealing operation of curtain round Pipe Roll Forming Machine
Jul 04, 2018

The curtain round Pipe Roll Forming Machine needs to select its flat table to a certain extent, and effectively stabilize the machine, so that the chassis feet can be pulled apart to make the machine panel easy to observe. To some extent, the plug on the hand-held sensor head needs to be inserted into the panel. The socket on the top is tightened and attention should be paid to the positioning gap.

  

The curtain round Pipe Roll Forming Machine needs to effectively insert one end of the plug of the power cord into the socket on the rear panel of the chassis, and the other end of the device is inserted into the power supply socket. Under normal circumstances, please use the single-phase three-wire power supply to open the rear panel of the chassis. On the “Power Main Switch”, press the “Power Switch” button on the panel. When the “Ready” green indicator light is on, the machine will work.

  

The curtain round Pipe Roll Forming Machine needs to place the sensor head on the container cover and press the start button on the handle. At this time, the “heating” red indicator light is on, indicating that it is heating, the sensor head is not removed, and the “heating” red indicator light is off. Then remove the sensor head and wait for the “prepare” green indicator light or the buzzer in the machine to beep “beep” to perform the sealing operation of the next container.


http://www.longborollformer.com/

Previous: Garage door forming machine productivity and rated load

Next: Precautions before and after the use of Perforated Rolling Shutter Roll Forming Machine